Getting Started

Detector Servers include:

• Control server [default port: 1952]

  • Almost all client communication.

• Stop server [default port: 1953]

  • Client requests for detector status, stop acquisition, temperature, advanced read/write registers.

When using a blocking acquire command (sls_detector_acquire or Detector::acquire), the control server is blocked until end of acquisition. However, stop server commands could be used in parallel.

Location

slsDetectorPackage/serverBin/ folder in every release.

Arguments

Possible arguments are:
   -v, --version            : Software version
   -p, --port <port>        : TCP communication port with client.
   -g, --nomodule           : [Mythen3][Gotthard2]
                              Generic or No Module mode. Skips detector type checks.
   -f, --phaseshift <value> : [Gotthard] only. Sets phase shift.
   -d, --devel              : Developer mode. Skips firmware checks.
   -u, --update             : Update mode. Skips firmware checks and initial detector setup.
   -i, --ignore-config      : [Eiger][Jungfrau][Gotthard][Gotthard2][Moench]
                              Ignore config file.
   -m, --master <master>    : [Eiger][Mythen3][Gotthard][Gotthard2]
                              Set Master to 0 or 1. Precedence over config file. Only for virtual servers except Eiger.
   -t, --top <top>          : [Eiger] Set Top to 0 or 1. Precedence over config file.
   -s, --stopserver         : Stop server. Do not use as it is created by control server

Automatic start

One can start the on-board detector server automatically upon powering on the board.

1. Create a soft link to the binary on board :

   ln -sf someDetectorServervx.x.x someDetectorServer
   

2. Do the following depending on the detector type :

   Eiger

   # create script in rc5.d on the board
   vi /etc/rc5.d/S50board_com.sh
   
   # enter the following (edit server name)
   #! /bin/sh
   /home/root/executables/eigerDetectorServer &> /dev/null &
   exit 0
   

   Jungfrau | Moench | CTB | Gotthard I

   # Edit inittab on board
   vi /etc/inittab
   
   # enter the following line
   ttyS0::respawn:/./xxxDetectorServer
   

   Gotthard II | Mythen III

   # create script in init.d on board
   vi /etc/init.d/S99detServer.sh
   
   # enter the following (edit server name)
   #! /bin/sh
   cd /root >> /dev/null
   /root/xxxDetectorServer >> /dev/null &
   

3. Sync, reboot and verify :

   sync
   
   # physically reboot for Gotthard II or Mythen III
   reboot
   
   # verify
   ps -ef | grep xxxDetectorServer